(1) Special reminder

　　The external power supply GPS tracker must be connected to the car power supply before it can work 24 hours a day. Generally, it is impossible for criminals to use this product to track other people's vehicles. Because it must be connected to the car power supply, it is different from the general external locator. Therefore, it is not recommended to use an external power supply.

　　(2) Installation method

　　1. If you know electricity, you can install it yourself. In fact, you only need to find the positive and negative poles of the car power supply. The negative pole is very easy to find. The place where the body is grounded is the negative pole. to the battery;

　　2. It is best to connect to the normal power supply, that is, the power cord directly drawn from the car battery that is not affected by the car key switch;

　　3. Note that the lighted side of the GPS locator should face the sky, and the side facing the sky should not be close to the metal object to block the internal GPS antenna. It also needs to receive satellite signals 20,000 kilometers away;

　　4. You can also ask relevant technical personnel to install it, and the fee depends on the local situation!

　　(3) Installation location

　　1. At the roof light above the front windshield;

　　2. The hidden place in the decorative panel under the front windshield;

　　3. Concealed places around the front dashboard;

　　4. In the door partition;

　　5. Under the decorative panel under the rear windshield;

　　6. Inside the front bumper, pay attention to waterproofing;

　　7. Under the wiper board, pay attention to waterproofing.

　　Note: If the windshield is pasted with a metal thermal insulation layer or a heating layer, it will reduce the GPS reception signal and cause the GPS to work abnormally. At this time, pay attention to changing the installation location of the device.

　　(4) Installation points

　　1. In order to avoid damage by thieves, the location of the equipment should be as concealed as possible;

　　2. Avoid putting it together with the emission source, such as wireless reversing radar, anti-theft device, and other in-vehicle communication equipment;

　　3. It can be fixed with a cable tie, or pasted with a wide sponge strong double-sided tape;

　　4. There are GSM antennas and GPS antennas in the device, and the front side should be up (to the sky) during installation.

Read recommendations:

OBD GPS Tracker

car gps tracker maker

10000mAh Magnetic Asset GPS Tracker

GPS centralized procurement layer.realtime gps tracker online manufacturer

Six characteristics of GPS