(1) The GPS positioner of the plug -in power supply must be connected to the automotive power supply before it can work for 24 hours. Generally, it is impossible to use this product to track other people's vehicles. Because it must be connected with the automotive power supply, the difference is generally a plug -in locator. Therefore, it is not recommended to use plug -in power.

　　(2) Installation route

　　1. If you understand the electricity, you can install it yourself. In fact, as long as you find the positive and negative electrodes of the car power supply, the negative electrode is very easy to find. Go to the battery;

　　2. It is best to connect to ordinary electricity, which is not affected by the car key switch. The power cord directly attracted from the car battery;

　　3. Note that the GPS positioner has a light side to the sky. Do not keep the metal object on this side of the sky to block the internal GPS antenna.

　　4. You can also ask the relevant technical personnel to install it, and the charges depending on the local situation!

　　(3) Installation location

　　1. The front windshield above the windshield;

　　2. The hidden part of the decorative board below the front windshield;

　　3. The hidden part of the front instrument panel;

　　4. In the door partition;

　　5. The decorative board below the windshield;

　　6. In the front bumper, pay attention to waterproof;

　　7. Under the wiper board, pay attention to waterproof.

　　Note: If the windshield is pasted with a metal insulation layer or heating layer, the GPS receiving signal will be reduced, causing the GPS to work abnormally. At this time, pay attention to replace the equipment installation position.

Read recommendations:

portable gps tracker distributors

vehicle gps tracker webfleet solutions

10000mAh Magnetic Asset GPS Tracker

Types of GPS chips used by common GPS receivers

Electric car is equipped with GPS positioning function and recovered the same day after being stolen