GPS locator installation

　　(a) external power GPS locator must be connected to the power supply of the car, can work 24 hours, general criminals want to use this product to track others' vehicles, it is impossible. Because it must be connected to the power supply of the car, it is different from the general plug-in locator. Therefore, it is not recommended to use external power supply.

　　(2) Installation way

　　1, if you know electricity, in fact, as long as you find the car power supply positive and negative, negative is very easy to find, the body of the iron place is negative, positive in the safety box, the car key switch near to find or directly connected to the battery;

　　2, the best normal electricity, is not affected by the car key switch, the power cord directly from the car battery;

　　3, pay attention to the GPS locator light side to the sky, towards the sky this side do not close to the metal block the internal GPS antenna, it also receives satellite signals 20,000 kilometers away oh;

　　4, also can ask the relevant technical personnel to install, the charge depends on the specific local situation!

　　(3) Installation position

　　1. Roof lights above the front windshield;

　　2. Concealed area in trim panel under front windshield;

　　3. Concealed area around front dashboard;

　　4. In the door partition;

　　5. Under the trim panel of the rear windshield;

　　6 front bumper inside, need to pay attention to waterproof;

　　7. Pay attention to waterproof under the wiper board.

Read recommendations:

Gps speed limiter Manufacturing

fleet gps tracking wholesale

G900LS J16-4G Car GPS Tracker

The difference between Beidou satellite and GPS.Pet GPS Tracker Manufacturing

Components of a GPS system