The car locator can monitor the specific information of the car in real time, and it is more and more applied to the leasing and car loan industry, as a tool for the risk control of car loan enterprises. In order to ensure the safety of automotive assets, the installation of the car locator cannot be sloppy.

　　The choice of the installation position of the car locator is very important, we know that the locator belongs to electronic products, the sensitivity and life of electronic products will be affected by environmental factors such as temperature, humidity, signal source is well known, so we should pay attention to waterproof, shockproof, anti-interference when choosing the installation position, and do the corresponding protection.

　　1. Install the GPS in strict accordance with the installation steps in the instructions provided by the manufacturer, and do not install it at will.

　　2, the wired car locator needs to be installed without power, and put in the SIM card, confirm the device and SIM connection is correct, and then switch on the host power.

　　3. The antenna receiving side of the car locator faces upward, the top can not be shielded by metal, lie flat, and the horizontal inclination shall not be greater than 15 degrees.

　　4, after the installation of the car locator, the test equipment is normal operation, you can drive the car to an open place, continue to power for more than one hour, test whether the positioning information is accurate.

Read recommendations:

fleet gps tracking supplier

4G GPS Tracker for vehicles company

Mini Sized GPS Tracker PCBA

Overview of GPS AGC working principle

GPS data